 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
|
 |
Time to stamp!!
Remove the stamp from it's storage sheet.
Place the stamp on the block. The back of the stamp will not be sticky. (Adheres by static cling)
Use a quality ink pad for best results.
Apply ink to stamp.
The clear acrylic block makes it easy to see where you are stamping!
Stamp image.
Rubber stamps make sharp, consistent images!
Clean stamp. Do not use harsh chemicals.
Gently peel clean stamp from acrylic block.
Return stamp to storage sheet.
Some stamps may require some minor trimming to eliminate edge smearing.
For consistent, quality images . . .
- Do not expose your rubber stamps to direct sunlight, excessive heat, smoke and dust.
- If the stamp is not “clinging” to the acrylic block, then make sure to clean the surface of the block with a mild detergent, rinse with water and dry it. The back of the stamp should be rinsed in clean water and allowed to air dry (paper towel or cloth may leave too much lint)
- Do not use oil-based products to clean or condition the stamp
- If desired stamps can be permanently attached to the acrylic blocks using a 3M double back sticky tape. We also offer a permanent wood mounting option. (Wood block ordering is availble on our acrylic block ordering page).
